Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 31)

28
See parts list drawing on page 20 and drawing on Page 28.
1. Remove load cell cover bolts (20) and lock washers (21) with
7/16” wrench and remove load cell cover (37 or 44).
2. Remove retaining ring (3) from lower cylinder pin with flat
head screwdriver.
3. There are two roll pins (17) inserted through the lower load
cell pin (34). Remove the roll pin at the end of the lower load
cell pin that prevents the load cell assembly from jumping off
the pin.
4. Loosen jam nut (19) on lockdown bolt (18) and turn
lockdown bolt in with 3/4” wrench.
5. Loosen socket head cap screw (10 and 11) with 3/4” Allen
key. Note: the cap screw and sleeve are pressed together and
should not be separated. Sleeve will come out with cap screw.
6. Remove pivot pin bolt (13), washer (15), and lock washer (14)
with 3/4” wrench.
7. Remove socket head cap screw (10 and 11) and lift arm
spacer (9).
8. Remove outer lift arm (5 or 7).
9. Remove upper load cell pin (31) and load cell assembly (32
and 33).
10. Remove upper cylinder pin (8) and hydraulic cylinder (1).
11. Remove inner lift arm (4 or 6).
12. Remove lower load cell pin (34) only if required by removing
the second roll pin (17) with roll pin punch and hammer.
-
Do not remove any hydraulic hoses unless you have a
qualified person to remove air from the system. The
hydraulic lines do not need to be removed to disassemble
the system.
13. Remove hydraulic fittings (55,56,57) only if required with
11/16” and 5/8” wrenches.
14. Check all bushings for excess wear. Replace the bushings if
necessary.
15. Bushings in the lift arms have been installed with Loctite. You
may need to heat the bushing only, to remove them.