Using auto setup, Notes – Yamaha HTR-6080 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Optimizing the speaker setting for your listening room
This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.
Using AUTO SETUP
Notes
■ Be advised lhat it is normal for loud test tones to be output
during the “AUTO SETUP” procedure.
■ To achieve the best results, make sure the room is as quiet as
possible while the “AUTO SETUP” procedure is in progress. If
there i.s too much ambient noise, the results may not be
satisfactory.
You can run “AUTO SETUP” using the system menu that
appears in the OSD or in the front panel display. This manual
uses the OSD illustrations to explain the “AUTO SETUP”
procedure.
Before performing operations, set the operation mode selector
on the remote control to (K)AMP
This unit uses the spetikers connected to the FRONT A speaker
terminals as the front speakers for the adjustment.
Make sure of the following check points
before starting the AUTO SETUP operations.
□
□
□
□
□
Speakers are connected appropriately.
Headphones are disconnected from this unit.
This unit and the video monitor are turned on.
The connected subwoofer is turned on and the
volume level is set to about halfway (or slightly
less).
The crossover frequency controls of the
connected subwoofer is set to the maximum.
The room is sufficiently quiet.
2
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
The following menu screen appears on the video
monitor.
3
Place the optimizer microphone at your
normal listening position on a fiat level
surface with the omni-directional
microphone heading upward.
Optimizer microphone
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears would
be when you are seated in your listening position. You can
use the attached screw of a tripod (etc.) to fix the optimizer
microphone to the tripod (etc.).
28
En