Speaker wiring i.i.i iri n6, Speaker size size, Speaker ievei l..i:eue:!l – Yamaha HTR-6080 User Manual
Page 34: Number of speakers ief, Speaker distance i) i: err, Speaker ievei i.ui, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Optimizing the speaker setting for your iistening room
This unit performs the following checks:
Speaker wiring i.i.i IRI N6
Checks which speakers are connected and the
polarity of each speaker.
Speaker size SIZE!!
Checks the frequency response of each speaker and
sets the appropriate low-frequency crossover for each
channel.
Speaker distance l)]dEfiMNCEt
Checks the distance of each speaker from the
listening position and adjusts the timing of each
channel.
Equalizing lEQUl-il...IZ: i N!3
Checks and adjusts the tonal characteristics of all the
speakers by the setting of “EQ”.
Speaker ievei L..I:EUE:!L
Checks and adjusts the volume level of each speaker.
The display changes as follows:
flUTCiiHEHU
tXis!PI bP HbblGN
JtRONT El
PFIElSEHCLt NONE
SETUP................ ■ ÑUTO
EQ..^-------H
h
TLIRRL
b I HR! I
[.».]/['*']!Up/Down
♦
liUTO; CHECK
IHITIRLIZING
W IF: I NS
SIZiE/[:'I5ir-lNCE
EQLIf-lL.IZIHG
L.EUEL.
iCHECK CH^-=CENTEE
RE:5ULT
bP :
:3.-'4.-'e. i
DIET! 14,0.-'17.0fl
LUL ! -9.0.-'+t..5dB
:>bET CPiNCEL
[i]/[T]!UFSDowri
[ENTERliEnlsr
The results displayed under “RESUL'T” are as
follows:
Number of speakers iEF'
Displays the number of speakers connected to this
unit in the following order:
Front/Back/Subwoofer
Speaker distance i) i: Err
Displays the speaker distance from the listening
position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker ievei I.UI..
Displays the speaker output level in the following
order:
Lowest speaker output level/Highest speaker output
level
Notes
• If ''E-IO:INTERNAL ERROR” appears during the testing
procedure, restart from step 4.
• If you selected other than ”AUTO” in step 5, no test tones
are output.
• If an error occurs during the “AUTO:CHECK” procedure,
the setup procedure is canceled and an error screen
appears. For details, see “If an error screen appears" on
page 32.
• When this unit detects potential problems during the
"AUTO SETUP” procedure, “WARNING” and the
number of warning messages appears in the above of
"RESULT” (sec page 32).
■ Depending on the listening environment, "SWFR
PHASE:REV” appears during the ”AUTO:CHECK”
procedure and “SUBWOOFER PHASE” in "SOUND
MENU” (see page 74) is automatically set to
“REVERSE”.
8 Press ® A and then ©ENTER to display the
setup resuits in detail.
♦
30
En