If an error screen appears, If “warning” appears, Note – Yamaha HTR-6080 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Optimizing the speaker setting for your iistening room
■ If an error screen appears
Press ® A / V / < / > to select “RETRY” or
“EXIT” and then press ©ENTER.
The following display is an example when “E-9:LJSER
CANCEL” appears in the OSD,
Choices:
RETRY,
EXIT
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
■ If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
“AUTO:RESULT” display. Check the warning messages
to correct your speaker settings.
Note
Warnings differ from errors in that w'arnings do not eaneel the
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press ©
int
ER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
Press ®o /1> repeatedly to toggle between
the warning displays.
yflRHIHGiy-
<CILIT OF F'HFISEi
Keoerse Cliannei
CENTER ^
i“'L
h'R
E pi j
E El R'
[ENTER] sEleturr,
• For detail«; about each warning me.ssage, see the "AUTO
SETUP'" section in "Troubleshooting" on page 99.
• When the corresponding warning message is not.
applicable to a speaker, "—" is displayed instead.
Press ©ENTER to return to the top
“AUTOiRESULT” display.
32
En