Yamaha HTR-6080 - Manual (Page 66)

Advanced sound configurations
■ Basic configuration of sound fieid
programs
Each sound field program has some parameters defining
the characteristics of the program. To customize the
selected sound field program, adjust “DSP LEVEL” and/
or “DIALG.LIFT” first, and then try other parameters.
To change sound field parameter settings, see page 61 for details.
Adjusting the effect sound level of the sound
field programs (DSP LEVEL)
Sound field programs add effect sounds (DSP effect
sounds) to the original source sound to create sound field
in the listening room. Use the “DSP
l £Y£L’' parameter to
adjust the level of the effect sounds.
Adjusting the vertical dialogue position
(DIALG.LIFT)
Use this feature to adjust the vertical position of the
dialogues in movies. The ideal position of the dialogues is
at the center of the video monitor screen.
-The ideal
dialogue
position.
[f the dialogues are heard at the lower position of the video
monitor screen, increase the value of “DIALG.LIFT”.
■;;0 =■ -A
:S ""
<>
□ □
__ OQ___.
The DSP effect
sound level is low.
The DSP effect sound
level is high.
Adjust “DSP LEVEL” as follows:
Increase the value of “DSP LEVEL” when
• the effect sound of the selected sound field
program is too weak.
• you cannot recognize any difference between the
sound field programs.
Decrease the value of “DSP LEVEL” when
• the sound is vague.
• you feel that the additional sound effect is
excessive.
Control range: -6 dB to 3 dB
r
Q
l J !
Move up to the Ideal dialogue position.
Choices: 0, 1,2, 3,4, 5
“0” (initial setting) is the lowest position, and “5” is the
highest position.
Notes
• “DIALG.LIFT” is only available only “EXTRA SP ASSIGN"
is set to “PRESENCE” (see page 72).
■ You cannot move the dialogue position down from the initial
dialogue position.
62
En