All channel search mode, Direct number access mode, Category search mode – Yamaha HTR-6080 User Manual
Page 59: Preset search mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
XM Satellite Radio tuning
Before performing the following operation!^, !^eiihe operation
mode selector on the remote control to
©SOURCE.
All
Channel Search mode
1
Press
©SEARCH MODE
(or
®SRCH
MODE)
repeatedly to select “ALL CH
SEARCH”.
2
Press ®
PRESET/TUNING/CH <3
/ > (or
® PRESET/CH
A
/
V)
repeatedly to search
for a channel within all channels.
3
Press
©PRESET/TUNING/CH
<a/t> (or
©PRESET/CH
A
/
V)
repeatedly to change
the preset channel number (1 to 8).
Yon can also select, the preset channel number directly by
pressing the nnmcric buttons (I to 8) ((§)).
■ Direct number access mode
1
Press ®
SRCH MODE
on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
■ You can search for a channel quickly by pressing and
holding
@)PRESET/TUNING/CH
<1/0 (or
®PRESET/CH
A / V ) .
■ To display the XM Radio ID number displayed in the front
panel display, select channel ”(r.
■ Category Search mode
1
Press ©SEARCH MODE (or ®SRCH
MODE) repeatedly to select “CAT SEARCH”.
2
Press ©CATEGORY (or ©A-E/CAT. <3 /1>)
repeatedly to change the channel category.
3
Press ©PRESET/TUNING/CH
< / >
(or
©PRESET/CH A / V ) repeatedly to search
for a channel within the selected channel
category.
You can search for a channel quickly by pressing and
holding
(DPRESET/TUNING/CH
< /> on the from
panel (or
©PRESET/CH
A / V on the remote cttnlrol).
■
Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see “Setting the XM Satellite Radio preset
channels” on page 56.
-'4'-
The initial factory setting of all preset channels (A I to E8) is
•■fOOl] Preview”.
1
Press ©SEARCH MODE (or ®SRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2
Press ©CATEGORY (or ©A-E/CAT.
<3 / O)
repeatedly to change the preset channel
group (A to E).
Press the numeric buttons (®) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (®) as shown below.
CLASSICAL
1
LIVE/CLUB
'The display changes as follows.
♦
♦
To enter a one-digit or tw'o-digit channel ntimber, press the
iiumeric buttons (®) on the remote eontrol and then press
@ENT
to confirm the input number.
Instead of pressing
(M)ENT
to tune into the channel
immediately, you
can wail a few seconds
until
this
unit
confirms the entered channel number.
If no button is pressed within a few seconds after you enter
a one-digit or two-digit number, this unit automatically
confirms the entered channel number.
Pressing a button other than the numeric buttons (®) or
@ENT
cancels the Direct Number Access mode
procedure.
55
En