Yamaha FX900 - Manual (Page 12)

5. The MEMORY Mode: Selecting Effect Programs
In the FX900 MEMORY mode, the [DATA ENTRY] control or
[A]
and
[T]
keys can be used to select individual effect programs.
When a new program number is selected, its number will fiash on the MEMORY display and its titie wiii appear on the upper iine of
the LCD (the abbreviated names of the active effects in the seiected program wiii appear on the bottom line). Press the [RECALL]
key to actually recall and activate the selected program.
NOTE: When a MIDI program change message is received for effect selection, an "M" wiii appear briefiy to the right of the lower
display line.
1. If the MEMORY mode is not already selected (i.e. if the
[MEMORY] key is not lit), press the [MEMORY] key to
select the MEMORY mode.
NOTE: If the UTILITY mode is active (i.e. the [UTILITY]
key is lit), it will be necessary to exit the
UTILITY mode before selecting the MEMORY
mode by pressing and holding the [UTILITY]
key until it goes out (about one second).
2. If necessary, use the [USER/PRESET] key to select the
USER or PRESET memory area.
3. Use the [DATA ENTRY] control or
[A]
and
[T]
keys to
select the number of the desired effect program. Press
the
[A]
or
[T]
key briefly to select the next highest or
lowest numbered program, or hold either key down for
continuous scrolling in the corresponding direction.
Faster scrolling is achieved by pressing the opposite
arrow key while holding the arrow key corresponding to
the direction of scrolling.
4. The number of the selected effect program should now
be flashing on the display, indicating that the program
has been selected but has not yet been recalled (the
previous effect program is still active). Press the
[RECALL] key to actually recall and activate the selected
program. The program number will stop flashing.
11