Peq — dual parametric equalizer – Yamaha FX900 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• PEQ — Dual Parametric Equalizer
A three-band parameteric equalizer with independent left- and right-channel settings.
Low
Mid
High
HPF
LPF
Low
Mid
High
HPF
LPF
Lch LoG LoQ LoF
-7 1.0 140
Rch LoG LoQ LoF
-7 1.0 140
Lch HiG HiQ HiF
+2 10 2.8k
Rch HiG HiQ HiF
+2 10 2.8k
Lch HiG HiQ HiF
0 3.2 7.0k
Rch HiG HiQ HiF
0 3.2 7.0k
Lch HPF LPF LVL
THRIiTHRU 0
Rch HPF LPF LVL
THRUTHRU 0
Lch LoG fLeft Channel Low Gain: -15 — +15 dB)
Sets the amount of boost or cut applied to the low-band
frequencies. A setting of + 0 produces no boost or cut. Minus
values produce cut and plus values produce boost.
Lch LoQ (Left Channel Low Quality Factor: 0.10 —10)
Sets the bandwidth of the low EQ band. Higher values
produce a sharper (narrower) bandwidth.
Lch LoF (Left Channel Low Frequency: 40Hz — l.OkHzl
Sets the center frequency of the low equalizer band.
Lch MIG (Left Channel Mid Gain: -15 — +15 dB)
Sets the amount of boost or cut applied to mid-band
frequencies.
Lch MIQ (Left Channel Mid Quality Factor: 0.10 —10)
Sets the bandwidth of the middle EQ band. Higher values
produce a sharper (narrower) bandwidth.
Lch MiF (Left Channel Mid Frequency: 250Hz — 4.0kHz)
Sets the center frequency of the middle equalizer band.
Lch HIG (Left Channel Hlah Gain: -15 — +15 dBl
Sets the amount of boost or cut applied to the high-band
frequencies.
Lch HiQ (Left Channel High Quality Factor: 0.10 —10)
Sets the bandwidth of the high EQ band. Higher values
produce a sharper (narrower) bandwidth.
Lch HIF (Left Channel Hlah Frequency; 0.1kHz — 16kHz)
Sets the center frequency of the high equalizer band.
Lch HPF fLeft Channel Hlah Pass Frequency: THRU.
20Hz-1.0kHzl
Sets the cutoff frequency of the left-channel high-pass filter.
The THRU" setting bypasses the filter.
Lch LPF fLeft Channel Low Pass Frequency; 1.0kHz —
16kHz. THRU)
Sets the cutoff frequency of the left-channel low-pass filter.
The "THRU" setting bypasses the filter.
Lch LVL
(Left
Channel Output Levef: -c«. -30 — +6 dB)
Sets the left-channel output level of the PEQ effect.
* The above parameters are all duplicated for the right
channel (Rch).
24