Yamaha FX900 - Manual (Page 34)

This sophisticated delay effect offers independently variable left and right channel delays.
• DL1 — Mono Delay 1
DLYL DLYR
300.0 600.0
FBD FB
150.0 +10
TYP CutF L/R
HPF THRU L=R
WID MIX LVL
4 60 0
DLYL (Left Channel Delay Time: 0.1 — 740.0 mS)
Sets the delay time of the left channel.
DLYR (Right Channel Delay Time: 0.1 — 740.0 mS)
Sets the delay time of the right channel.
FBP (Feedback Delay Time: 0.1 — 740.0ms)
Sets the delay time before feedback begins. This makes it
possible to produce a longer delay before a series of
relatively short feedback repeats begins.
FB (Feedback: -100 - ■i-lOO % )
Determines the amount of effect-sound feedback returned to
the input of the processor. Negative values produce out-of­
phase feedback. Higher values produce a greater number of
repeats.
TYP (Feedback Filter TVoe: HPF. LPF)
Selects the type of feedback filter to be used with the Mono
Delay effect: HPF = high-pass filter; LPF = low-pass filter.
Please note that whenever the setting of this parameter is
changed, the "CutF" parameter, below, is automatically set to
"THRU".
CutF (Filter Cutoff Frequency: THRU. 160Hz —
1.0kHz/1.0kHz-11kHz.THRU)
Sets the cutoff frequency of the filter type selected in the
preceding parameter (TYP). If the HPF is selected, the range
is from 160Hz to 1 .OkHz. If the LPF is selected the range is
from 1 .OkHz to 11 kHz. In either case the "THRU" setting
bypasses the filter.
L/R fLeft/Rlaht Delay Balance: L50 - L1. L=R. R1 -
R50I
Sets the balance between the left- and right-channel delay
sound. A setting of "L50," for example, produces only the
sound of the left-channel delay. "L=R" produces both
channels in equal balance. "R50" produces only the sound of
the right-channel delay.
MIX fMIxIna Balance: 0 -100%)
Sets the balance between the direct and effect sound. Higher
values produce a greater proportion of effect sound in relation
to direct sound.
LVL (Output Level: -° q . -30 — +6dB)
Determines the output level of the DL1 effect.
33