Yamaha FX900 - Manual (Page 19)

Memory Store
An edited effect program can be stored in any memory
location within the FXQOO's USER memory area (0 through
99). Original effect programs stored in this way can be
selected and used in exactly the. same way as the preset
effect programs. The ON/OFF status of each effect, the
selected algorithm, and effect assignments, are stored along
with all other parameter data. The UTILITY mode TITLE
EDIT function can be used to create new titles for your
original effect programs after you have stored them in USER
memory.
EDIT STORE
1. After editing the parameters to create the desired effect,
select the MEMORY mode and select the USER
memory location (0 — 99) to which you wish to store the
edited data (do not press the [RECALL] key).
2. Press the [STORE] key.
STORE OK ?
pre : 1 •> usr : i 2
3.
In this example, an edited version of PRESET program
1 will be stored to USER memory location 12.
Press the [STORE] key again. The following display will
appear for a few seconds while the store operation is in
progress. If you decide not to go ahead with the store
operation, simply press any key other than the [STORE]
key.
MEMORY STORE
pre : 1 ^ usr : i 2
4. When the store operation is complete, the memory
location stored to will be selected automatically (the
MEMORY number display will stop flashing).
5. Use the UTILITY mode TITLE EDIT function to give your
program an original name. The TITLE EDIT function is
described in detail on page 42.
NOTE: If you attempt to use the STORE function while
a ROM memory location is selected, the
following display will appear and the store
operation will be aborted.
CANNOT STORE
PRESET AREA
18