360 Systems TCR Multi-Track - Manual (Page 48)

3-4 Installation TCR Series User's Manual
Connecting Signals
This section provides instructions for connecting signals to the TCR. The following topics are
discussed:
•
Audio I/O Connection
•
Sync and Reference Connections
•
Control Connection
In Chapter 1, refer to the “Rear Panel Description” section for an illustration and explanation of all
rear chassis connectors.
See Chapter 5, “Machine Setup” for detailed information on configuring I/O.
Audio I/O Connection
During system setup, you can specify which combination of TCR digital and analog inputs that you
wish to use.
Digital I/O Connection
To connect digital inputs and outputs to the TCR, plug 3-pin XLR cables from the digital I/O sections
of the TCR’s rear panel to the digital I/O sections of your other equipment. TCR digital I/O is
AES/EBU standard, only.
Analog I/O Connection
To connect analog inputs and outputs to the TCR, plug 3-pin XLR cables from the analog I/O
sections of the TCR’s rear panel to the analog I/O sections of your other equipment. TCR analog I/O
is a line level signal, only.
Sync and Reference Connections
The following topics are discussed in this section:
•
VITC Connection
•
Video Connection
•
LTC Connection
•
Word Clock Connection
For reference termination requirements in the connection procedures, refer to the following diagram:
0
I
WCLK TERM VITC TERM VIDEO TERM S4
S1 S2 S3
Signals will be terminated when their corresponding switch is set to the “|” position.