360 Systems TCR Multi-Track - Manual (Page 58)

4-8 Operations TCR Series UserManual
Basic Recording
Full Record
Arm the desired tracks, then press REC + PLAY to place the TCR in record mode. The recording
starts at the position that is indicated in the Time Code Display. To conclude the recording:
•
Press STOP to end the recording and stop the transport.
•
Press PLAY to punch-out of record mode, but keep the transport rolling.
Punch-In Record
Arm the desired tracks, then press PLAY to place the TCR in play mode. Press PLAY + REC at any
point to punch-in to record mode at the current time line location. To conclude the recording:
•
Press STOP to end the recording and stop the transport.
•
Press PLAY to punch-out of record mode, but keep the transport rolling.
Punch-In Recording using the Arm Buttons
While recording is in progress, you may toggle any of the ARM buttons to punch-in or out of record
on specific tracks.
Automatic Edit Point Updates
You can continue to punch in and out of record mode as often as required. When done, the Edit-In
register contains the location of the start of the crossfade of the first punch-in point. The Edit-Out
register has the location of the end of the crossfade of the last punch-out. Thus, you can press Review
after the recording operation to playback the new material between Edit-In and Edit-Out
Automatic Recording
In addition to setting the normal recording parameters discussed above, the following parameters
should be established before Auto Recording:
•
Edit-In and Edit-Out points
•
Pre-roll and post-roll duration
Setting Edit Points
The Edit-In and Edit-Out points are included in the list of special time code locate values that may be
stored and recalled. See the section “Using the Locate Register” below. They may also be accessed
quickly using the Edit-In and Edit-Out buttons.
Jog to the desired edit point and use the CAPTURE button to place the current position into the LOC
Register. Then press STORE followed by EDIT IN or EDIT OUT to establish the edit point.