Cub Cadet RZT-S Zero Electric User Manual
Page 58
Advertising
RZT-S Zero
54
10.
Plug the steering sensor into the harness.
11.
Install the yoke cover:
11a. Place the two spacers over the screw holes in the axle casting with the necked in side facing up.
11b. Place the star washers on top of the spacers.
11c. Position the cover for installation.
11d. Install the screws using a 7/16” wrench.
12.
Install the floor pan by following the procedures described in Chapter 2: Body.
13.
Calibrate the steering sensor by following the procedures described in the Steering and TPS calibration sec-
tion of this chapter.
14.
Test drive the mower in a safe area before returning it to service.
Advertising