Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 31)

17 Cabling
Installation
Step 7. Use the up or down arrow to move the cursor in
front of “Baud Rate”. (See Fig. 40)
Step 8. Use the left or right arrows to move through the
Baud Rate list. There are 3 baud rates to choose
from:
125 K
250K
500K
Step 9. Once you have made the Baud Rate selection press
the Enter button to set the parameter in the instru-
ment.
Step 10. Use the down arrow to move cursor in front of
“Node Address”. (See Fig. 41)
Step 11. Use the left or right arrows to move the scroll list.
Nodes number from 0 to 64.
FIG. 41: DEVICENET/SELECTING NODE ADDRESS
Step 12. When you have selected the correct node number
for the HI 3000 instrument, press the Enter button.
Step 13. Press the Exit button until you are back to the
standby display.
For HI 3030, HI 3600, HI 3300
Step 1. At the front panel click on the Setup button. The
Configuration Menu appears. (See Fig. 42)
FIG. 42: CONFIGURATION MENU/SELECTING
SETUP
Step 2. Push the up or down arrows until the cursor is next
to “OPTION”. (See Fig. 43)
Step 3. Press the Enter button. The Options sub-menu
appears. (See Fig. 44)
FIG. 43: CONFIGURATION MENU
FIG. 44: OPTIONS MENU/SELECTING DEVICENET
I/O
Step 4. To toggle Devicenet on or off press the right or left
arrow buttons. Notice when Devicenet is toggled
ON there is an arrow to the right of “ON”. The
arrow indicates another sub menu.
Step 5. Press the Enter button. The Devicenet sub-menu
appears. (See Fig. 45)
FIG. 45: DEVICENET SUB-MENU/SETTING THE
BAUD RATE
Step 6. Use the up or down arrow to move the cursor in
front of “Baud Rate”. (See Fig. 45)
Step 7. Use the left or right arrows to move through the
Baud Rate list. There are 3 baud rates to choose
from:
125 K
250K
500K
Step 8. Once you have made the Baud Rate selection press
the Enter button to set the parameter in the instru-
ment.
Step 9. Use the down arrow to move cursor in front of
“Node Address”. (See Fig. 46)
Step 10. Use the left or right arrows to move the scroll list.
Nodes number from 0 to 64.
>
CONFIGURATION MENU
CALIBRATION - >
OPTIONS - >
I/ O MAPPING - >
>
OPTIONS MENU
Remot e I/ O
Devicenet I/ O ON - >
Cont r ol Net I/ O OFF - >