Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 99)

85 Network
Installation
Step 18. This completes the EtherNet/IP configuration for
the Hardy HI 3000 Modules.
Mapping
Mapping is used to:
1. Configure local inputs and outputs of the 3000 Con-
troller using Boolean or non-Boolean statements.
2. Map parameters between Controllers using an
Ethernet Network. (Hardy Control-Link)
3. Map parameters, setpoints, or commands between
the local controller and any of the supported com-
munication networks, including ControlNet, Allen-
Bradley Remote I/O, Profibus and DeviceNet.
Note: The 3000 Controllers are Masters on DeviceNet,
meaning any parameter can be assigned (mapped) to 3rd
party I/O on the DeviceNet Network. The Rockwell Auto-
mation software package "RSNetworx" is used to assign the
I/O on the plant network.
Any number of Sources can be mapped to one Destination
using the Boolean Statements in the Advanced Mapping
Screen.
Step 1. Select One Destination from the pull down lists in
the Local, Network, or Control fields. Once
selected, the Destination will automatically fill in
on the left-hand side of the equation in the mapping
field.
Step 2. Select one Source in the same manner as in step a.
The source can reside in the local controller as a
parameter, as a point on one of the network tables,
or as a parameter on another 3000 Controller on the
network. Once selected, the source will automati-
cally fill in on the right-side of the equation in the
mapping field.
Step 3. If more than one source is desired, select one of the
Boolean Operators (And, Or, Not), and then repeat
step 2 to select the next source.
Step 4. To initiate the displayed mapping equation, select
the 'Map' key.
Step 5. To Unmap - Highlight the Mapping you want to
unmap. Copy and paste the map into the Map text
field. Press the Unmap button. The Mapping disap-
pears from the list.
Step 6. For more information about Mapping go to the
Mapping Chapter for each individual HI 3000
Series product.