Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 57)

43 Network
Installation
FIG. 118: HARDWARE/VENDOR/HARDY
INSTRUMENTS INC. INSTALLED
Step 15. Click on the graph tab.
Step 16. Click on the + sign in the box next to Hardy Instru-
ments, Inc. The Communication Adapter folder
flies out.
Step 17. Click on the + sign next to the Communication
Adapter and the Hardy Series 3000 Instrument
appears next to the Instrument Icon. In our example
the Hardy Filler HI-3010.
Step 18. Double click on the Hardy Filler Icon and it appears
in the graph with value 00. (See Fig. 119)
Step 19. The EDS file installation is complete.
FIG. 119: GRAPH/HARDY FILLER ICON
Slave Mode Setup
The DeviceNet Module can operate in Master or Slave
mode. To set the module to the slave mode, perform the fol-
lowing procedures.
Step 1. Double Click on the Hardy Filler Icon. (See Fig.
119) The Hardy Filler Property List appears with
the General Tab selected. (See Fig. 120)
Step 2. Click on the Module tab.
FIG. 120: MODULE TAB/SELECTING SLAVE MODE
Step 3. Click on the Slave Mode button. (See Fig. 120) The
Slave Mode dialog box appears. (See Fig. 121)
FIG. 121: SLAVE MODE DIALOG BOX
Step 4. Click in the check box next to “Enable Slave
Mode” to enable the Slave Mode.
Step 5. Under Polled set the number of bytes for the Rx and
Tx Sizes.
Step 6. Click on the OK button.
Step 7. Click on the Input Tab. The Input Page appears.
(See Fig. 122)
Step 8. Click on the AutoMap button to Map the Inputs.
(See Fig. 123)