Block read command number 10: sticker value, Block read command number 10: sticker value -11, Chapter 5 - block transfers – Hardy HI 2151/30WC Single-Scale Controller User Manual
Page 31
Chapter 5 - Block Transfers
5-11
TABLE 5-12: BLOCK READ COMMAND NUMBER 9: CONFIGURATION OF STANDARD RS232 PORT
Block Read
Command Number
10: Sticker Value
HI 2151/20WC Only.
NOTE:
Sticker Value is not used in the HI 2151/30WC
TABLE 5-13: BLOCK READ COMMAND NUMBER 10: STICKER VALUE
Word Length
bits 0 - 7
A value of 0 or 1 [0 = seven bits, 1 = eight bits*
Handshake Control
bits 8 - 15
A value of 0 or 1 (0 = Hardware, 1 = Software
*Note: Parameters are not used in the HI 2151/30WC
1
4
Echo
bits 0 - 7
A value of 0 or 1 (0= Off, 1 = On)
Device Address
bits 8 - 15
A value from 0 to 99
1
5
TOTAL NUMBER OF WORDS
6
BLOCK READ COMMAND NUMBER 9: Configuration of Standard RS232 Port
START
WORD DEFINITIONS:
#WORDS
WORD
BLOCK READ COMMAND NUMBER 10: Sticker Value (HI 2151/20SC Only)
START
WORD DEFINITIONS:
#WORDS
WORD
Command number: A value of 10 (decimal)
bit 0
0
bit 1
1
bit 2
0
bit 3
1
bit 4
0
bit 5
0
bit 6
0
bit 7
0
bits 8 - 15
Reserved for future use
1
0
Sticker Value
A 20 bit number in proper integer format
2
1
TOTAL NUMBER OF WORDS
3