Block write commands, About block write commands, Block write commands -14 – Hardy HI 2151/30WC Single-Scale Controller User Manual
Page 34: About block write commands -14, Lock transfer read example -14, Lock transfer write example -27
Advertising
HI 2151 SERIES WEIGHT CONTROLLERS REMOTE I/O OPTION
5-14
FIG. 5-1 BLOCK TRANSFER READ EXAMPLE
Block Write Commands
About Block Write
Commands
After the PLC performs a block transfer write, a block read should be
performed to evaluate the response code from the HI 2151 to verify that
the data was received and implemented. The response word will either
show a successful processing of the block or will indicate the first error
encountered in processing of the data.
NOTE:
Setpoints, deadbands and preacts can all accept negative values. To enter negative
values, use the “twos complement” method.
NOTE:
Block Writes cannot be performed while the instrument is in calibration mode. The
calibration must be sealed by pressing enter at Endcal.
Advertising