Hardy HI 2151/30WC Single-Scale Controller - Manual (Page 43)

Chapter 5 - Block Transfers
5-23
TABLE 5-25: BLOCK WRITE COMMAND NUMBER 58: CONFIGURATION OF ANALOG OUTPUT
Block Write
Command Number
59: Configuration of
Standard RS232
Port HI 2151/20WC Only.
Weight value represented by a zero scale analog output: 2 1
Weight value represented by a full scale analog output: 2 3
TOTAL NUMBER OF WORDS 1
BLOCK WRITE COMMAND NUMBER 58: Configuration of Analog Output
START
WORD DEFINITIONS: #WORDS WORD
BLOCK WRITE COMMAND NUMBER 59: Configuration of Standard RS232 Port
START
WORD DEFINITIONS: #WORDS WORD
Command number: A value of 59 (decimal)
bit 0 1
bit 1 1
bit 2 0
bit 3 1
bit 4 1
bit 5 1
bit 6 0
bit 7 0
bits 8 - 15 Reserved for future use
1 0
Format of Communication
bit 0 Print Initiation (1 = altered print, bit 6 must = 0)
bit 1 Setpoint, Deadbands, and Preact values transmitted
bit 2 Rate-of-Change Transmitted
bit 3 Tare Weight Transmitted
bit 4 Net Weight Transmitted
bit 5 Gross Weight Transmitted
bit 6 Print initiation (0 = continuous, 1 = print button, bit 0 must = 0
bit 7 - 15 Reserved for future use
1 1
Port Configuration
bits 0 - 7 A value of 0 or 1 (0 = Bi-Directional, 1 = Printer (output) only)
Baud Rate
bits 8 - 15 A value of 0 to 5 (0 = 600, 1 = 1200, 2 = 2400, 3 = 4800,
4 = 9600, 5 = 19200
1 2
Parity
bits 0 - 7 A value of 0 to 2 (0 = None, 1 = Even, 2 = Odd)*
Stop Bits
bits 8 - 15 A value of 0 or 1 (0 = one stop bit, 1 = two stop bits)*
*Note: Parameters not set by HI 2151/30
1 3
Word Length
bits 0 - 7 A value of 0 or 1 (0 = seven bits, 1 = eight bits)*
Handshake Control
bits 8 - 15 A value of 0 or 1 (0 = Hardware, 1 = Software)
*Note: Parameters not set by HI 2151/30
1 4