Industrial Data Systems IDS 410 - Manual (Page 51)

IDS 410/422 User's Manual
50
Diagnostic Test 11: Print the EAROM Configuration Table
This function sends the contents ot the EAROM configuration memory to the printer. Use this
function to document your setup of the when installation is complete.
Diagnostic Test 12: Serial Communications Port 1 - Loop Back Test
This test is used by the factory to test the serial ports transmit and receive functions. The
transmit and receive lines must be jumpered together and the clear-to-send must be jumpered to
data-terminal-ready for this test.
Diagnostic Test 13: Serial Communications Port 2 - Loop Back Test
This test is used by the factory to test the serial ports transmit and receive functions. The
transmit and receive lines must be jumpered together for this test.
Diagnostic Test 14: Display Time and Date
This test will display the Time and Date. Note: The optional clock must be installed.
Function 72: Scale Basic Function Editor
Use function 72 to create or modify Scale Basic Functions. See the “ Scale Basic / Event
Monitor” manual for more information on Scale Basic Functions.
1.Hold down the GROSS/NET key and depress the UNITS key to enter the configuration mode.
2.Enter CFG 72. The IDS 410/422 prompts “Fn”. Enter the function number to be modified.
3. The IDS 410/422 prompts “0-xxx” where 0- is the entry zero, and xxx is the current value for
entry zero. Enter new data for 0- or press the ENTER key to use the displayed data.
4. Use the UNITS key – or the GROSS/NET key + to scroll through the entry numbers. Press the
CLEAR key to exit from the function editor.