Industrial Data Systems IDS 410 - Manual (Page 9)

IDS 410/422 User's Manual
8
INSTALLATION AND SETUP
This section provides information about unpacking, installing, and setup of the IDS 410/422. It
also directs the installer to the appropriate sections of the manual for hardware and setup
installation.
Unpacking the IDS 410/422
Installation begins with unpacking the IDS 410/422. Observe any instructions or cautions which
appear in the shipping container. Check the items in the shipping container against the following
item check list or the packing list. IDS, Inc. will not accept responsibility for shortages against
the packing list unless notified within 30 days. All equipment and accessories are inspected and
tested by IDS before shipment. Inspect the equipment carefully. If shipping damage is evident,
notify the carrier immediately. Take photographs if necessary. You are responsible for final
claim and negotiations with the carrier. Save the packing and shipping container in case you
need to store, return, or transport the IDS 410/422 for any reason.
Item check list
(1) IDS 410/422 - Weight Indicator w/power cord.
(1)This User's Manual.
(2) Capacity labels and (2) transparent overlays.
(1) A sheet that describes the capacity label placement.
(1) Package of fasteners for the IDS 410/422 back panel.
NOTE: The container may include additional items that have been purchased separately.
Installation Guide
WARNING!! Do not apply power to the unit until all connections are completed as described
in this section and the access panel has replaced and secured onto the back of the IDS 410/422.
Connect IDS 410/422 to load cell or junction box
Connect the load cell or junction box to the Load Cell Terminal Block (TB1) located inside IDS
410/422's enclosure. See the HARDWARE INSTALLATION AND WIRING section (page 8-1)
for pin assignments and a sample cable drawing.
Connect IDS 410/422 to the printer (optional)
The IDS 410/422 can be connected to a printer using Com Port 1 (TB3) for RS232 or Current
Loop interfaces. See the HARDWARE INSTALLATION AND WIRING section (page 8-2) for
pin assignments and sample cable drawings.