KORG Soundlink DRS REcording Console 168RC - Manual (Page 19)

Chapter 1. Basics
4. Reading the LCD
Program number/name
This is the name and number of the current program. When saving or recalling, it will be high­
lighted until the number is input.
Program update mark
Immediately after a program has been recalled, a will be displayed here. When a knob or fader
is moved to modify the contents of the program, this display will change to an "sf-".
Channel number
This is the channel number. Press the [SEL] keys (or the [SOLO] keys) to select a channel.
Page name
This is the name of the current page.
Overload indicator
When an analog input A~H signal exceeds the maximum level, a "O" will be displayed here.
Adjust [PAD] or [TRIM]. Distortion which occurs in the analog section cannot be corrected by
fader operations.
MIDI receive indicator
When MIDI messages are received, an "M" will be displayed here.
Solo indicators
The four dots below "SOLO" are the solo indicators for channels 13~16. From the left, they repre­
sent channels 1 3 , 1 4 , 1 5 and 16, and solo is on when the dot is displayed.
If during cascade connection (p.77), a command to monitor the solo bus is received via MIDI,
"SOLO" will change to "SOLO-A".
Program
number
Program update mark
Program name
Channel number
P.00+Preset PGM
1 A£ A
0 AH
Page name Overload indicator
Meter
AE A& A7 A$ ^ ES Bi; A F G H
. MIDI receive
indicator
Ch. 13-16
solo indicators
■ -
- - 2 > t -
- - a s -
Peak
U Hold
J . 1 2 3 4 5 6 7 8 ^B9I0 11
Recall/save
program number
- 1 2 - ;
- 2 4 -
- a s -
Cascade master
solo active receive
I I I l i i i j k i 1 1 m j -
Al A£ AS A4 as AS A7 AS B1 B£ BS B4 A F G
0
Peak
Hold
1 2 3 4 5 6 7 S 9 10 11 12 13 14 15 le
1 2