KORG Soundlink DRS REcording Console 168RC - Manual (Page 24)

3. Setting the clock source
2. Turning on the power
Turn on the power of each connected device.
A
Please be careful of the order in which you turn on/off the power of each device. If you
perform this procedure incorrectly, your speakers or amp may be damaged.
Before turning the power on, set the volume of all devices to the minimum position, and
then turn on the power switches beginning with the devices that output the signals. When
turning the power off, reverse the power-on sequence.
O Turn the volume of all external devices (keyboard, amp, etc.) down to the minimum position.
Q Turn on the power of the keyboard, the adat, and the master recorder (DAT).
0 Turn on the power of the 168RC.
After the opening message is displayed, one of the mode displays will appear. The 168RC will
show the mode display that was last-selected when the power was turned off.
O Turn on the monitor amp power.
0
Press the adat's [DIGITAL INPUT] switch. This will connect the 168RC's group bus to the
adat's input.
3. Setting the clock source
Set the clock source of the adat to match the 168RC.
O If you have an adat XT, set CLOCK SELECT to DIG 48K.
If you have an adat, the operation in step
0
will make it operate using the I68RC's clock.
0
Press the 168RC's [MISC] key (the LED will light) to access MISC mode. Press the [ /S ] or
[ \/ ] key to select CLK Source in the System page, and select "INTERNAL" either by rotating
knob [3] or [4], or by pressing the [+] or [-] key.
ROM Uersion!l.0
17