KORG Soundlink DRS REcording Console 168RC - Manual (Page 31)

Chapter 2. Tutorial
13. Apply an effect to the signal sent from the master L/R
Use the internal effect 2 to apply reverb to the signal which is input to channels 1 and 2 from the
adat, and send it to master L/R.
O In the Eff 2 I/O page of EFF2 mode, turn Eff 2 "ON".
@ Send the effect output to adat tracks 1 and 2. In the Eff 21/0 mode page of EFF2 mode, turn
Mstr "ON." Turn all others "OFF".
set PGM Ch y >EN'2 I/O
Gl/2 63/4 G5/6 G7/8
5) B) O
Eia nffl Ba BH
O In the Eff 2 Edit page of EFF2 mode, set TYPE to "00" Reverb Hall, and press "ENTR" (knob
[8]).
o
In I/S/P mode, adjust the Eff 2 Level for channels 1 and 2.
0 In Mstr.Level of SND MASTER mode, turn the Eff 2 switch "ON", and adjust the level.
14. Record to the adat
Preparations for recording to the adat have now been completed. Once again, check that the adat
meters indicate an appropriate level. Then put adat tracks 1 and 2 in Track Rec mode, and record
your performance.
15. Overdub
The process of recording additional tracks while monitoring previously recorded tracks is called
"overdubbing." Add additional input sources, and overdub them to other tracks. The signals from
168RC group buses 1~8 will pass through the adat OPTICAL OUT A (1-8) and be sent to tracks
1~8 of the adat.
16. Mixdown
When all recording has been completed, make adjustments for each channel. Apply EQ, limiting,
and reverb etc., and mixdown to your master recorder (DAT).
17. Listen to the master
Set the [TAPE IN/MONITOR] switch to the "TAPE IN" position, and playback the master re­
corder (DAT).
24