KORG Soundlink DRS REcording Console 168RC - Manual (Page 39)

Chapters. Parameters
Here you can specify the correspondence between program change numbers and the program
numbers of the 168RC. For each program change number, you can specify the 168RC program to
which it will correspond. This correspondence will be in effect only when the MIDI Setup page
parameter Program Change No. is set to "User."
000...099
[P.No]
[EXIT]
The MIDI program change number.
The 168RC program number. Rotate knobs [2] to assign the program.
Return to the MIDI MENU page.
Parameter Menu (Param. Menu)
Here you can make preparations for entering the Parameter Mapping page.
Type "Typel, Type2, User"
Select the type that will be displayed in the Parameter Mapping page. "Typel" and "Type2" are
fixed mappings which cannot be changed, and "User" allows you to specify the MIDI channel
and control change number for each 168RC parameter number.
The selection you make here has no effect on the actual MIDI messages, which will follow the
Parameter Number settings.
Jump to "Foders, Mute,..., INPUT", "No.OO 1 ...No.617"
Specify what will be displayed first in the Parameter Mapping page. This can be selected either by
the 168RC function name, or by the parameter number.
(SECT) selects either function name or parameter number. [ENTR] accesses the following Param­
eter Mapping page. [EXIT] returns to the MIDI MENU page.
Parameter Mapping (Param. Map)
001:Chi Fader Ich :
I
#00
S002:Ch2 Fader Idh E #01
003:Ch3 Fader Ich : #02
004:Ch4 Fader Ich : #03
005:Ch5 Fader Ich : #04
(QFSTXCTN
q
XEXIT]
Here you can assign a MIDI channel offset and control change number for each function name
(001:Fader...617;SOLO MODE) of the 168RC. If two or more 168RC functions are assigned to the
same control number of the same MIDI channel, the lowest-numbered function will be controlled.
In order for these settings to take effect, the MIDI Setup page setting Parameter Number must be
set to "User." If the Parameter Menu page setting Type is either "Typel" or "Type2," this page will
be only for your reference, and it will not be possible to modify the values.
(OFST): Specify the MIDI channel for transmission and reception. This setting is relative to Tx
Base Ch and Rx Base Ch: i.e., [Tx Base Ch (Rx Base Ch)] + [this setting] = [channel for actual
transmission (reception)]. If the value exceeds 16, it will wrap around to 1.
Example: Rx Base Ch "12" + this setting "ch.6" = 18 -> ch.2 will be used for reception.
(CTNo): Specify the MIDI control change number that will be transmitted and received.
[EXIT]: Return to the Parameter Menu page.
32