KORG Soundlink DRS REcording Console 168RC - Manual (Page 3)

THE FCC REGULATION WARNING
This equipment has been tested and found to compiy with the iimits for a Ciass B digitai device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation,
this equipment does cause harmful interference to radio or teievision reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the foilowing measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CANADA
THIS APPARATUS DOES NOT EXCEED THE “CLASS B” LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS SET
OUT IN THE RADIO INTERFERENCE REGULATION OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
LE PRESENT APPAREIL NUMERIQUE N’EMET PAS DE BRUITS RADIOELECTRIQUES DEPASSANT LES LIMITES APPLICABLES
AUX APPAREILS NUMERIQUES DE LA “CLASSE B” PRESCRITES DANS LE REGLEMENT SUR LE BROUILLAGE
RADIOELECTRIQUE EDICTE PAR LE MINISTERE DES COMMUNICATIONS DU CANADA.
CE mark for European Harmonized Standards
CE mark which is attached to our company’s products of AC mains operated apparatus until December 31, 1996 means it conforms to
EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC).
And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/336/EEC), CE mark Directive (93/68/EEC)
and Low Voltage Directive (73/23/EEC).
Also, CE mark which is attached to our company’s products of Battery operated apparatus means it conforms to EMC Directive (89/336/
EEC) and CE mark Directive (93/68/EEC).
Phantom Power
To prevent hazard or damage, ensure that only microphone cables and microphones designed to IEC-268-15A are connected.
Precautions
■ Location
Using the unit in the following location can result in
malfunction.
• In direct sunlight
• Locations of extreme temperature or humidity
• Excessively dusty or dirty locations
• Locations of excessive vibration
■ Power supply
Please connect the AC power cable to an AC outlet of
the correct voltage. Do not connect it to an AC outlet of
voltage other than for which your unit is intended.
I Interference with other electrical devices
This Unit contains a microcomputer. Radios and televi­
sions placed nearby may experience reception interfer­
ence. Operate this unit at a suitable distance from radios
and televisions.
I Handling
To avoid breakage, do not apply excessive force to the
switches or controls.
I Care
If the exterior becomes dirty, wipe it with a clean, dry
cloth. Do not use liquid cleaners such as benzene or
thinner, or cleaning compounds or flammable polishes.
I Keep this manual
After reading this manual, please keep it for later
reference.
About the 168RC’s backup battery
The 168RC contains a backup battery to preserve the contents of memory when the power is turned off. When the LCD
shows “IE01 Battery” it is time to replace the battery. Please contact your dealer or a service center.
About data backup
When shipped from the factory the 168RC contains various programs and EQ and effect setting (168RC MEMORY
LIST). If you save new data in these memories the original data will be lost, and cannnot be recovered.
Unintended operations may result in the erasure of the memory contents. Be sure to save important data to an external
data filer (storage device). Also, please be aware that the Korg Corporation can accept no responsibility for any dam­
ages which might result from loss of data.
adat and Alesis are registered trademarks of the Alesis Corporation,
adat Digital Interface is a trademark of the Alesis Corporation.