KORG Soundlink DRS REcording Console 168RC - Manual (Page 68)

18: Multiband Limiter
18: Multiband Limiter
This effect applies separate limiters to the low range, mid range, and high range of the input
signal. Since you can control the dynamics for each frequency range, you can compress the low,
mid, and high ranges in a way different than when an equalizer is used.
Band'Pass FUters
' Low
Limiter
Envelope - ControT)-—
Mid
Offset LOW
Limiter
Envelope - ControT)--—^
Output
LEVL
Output
~
PAN
__A High Offset MID
Limiter
Envelope - Control '
-
0
-—°
Output
LEVL
Offset HIGH
Limiter RTIO 1.0:1...50:1, inf; 1 Set the compression ratio. >®’p.59
Limiter THRE -40...0 dB Set the level from which compression will occur. IIS’ p.59
ATCK 1...100 Set the attack time. 'S’p.60
RLSE 1...100 Set the release time. ■ ®’p.60
Offset LOW -40...0dB Set the gain of the low range trigger signal.
Offset MID -40...0dB Set the gain of the mid range trigger signal.
Offset HIGH -40...0dB Set the gain of the high range trigger signal.
For example, if you do not want compression to be ap­
plied to the high range, adjust Offset HIGH to lower the level
of the high range trigger signal so that it is lower than the
THRE (Threshold) level. This will mean that the high range
limiter will not respond, and compression will not be ap­
plied.
Output PAN L50...L01, CNT, ROl ...R50 Set the stereo location of the output.
Output LEVL 0...100 Set the output level.
61