KORG Soundlink DRS REcording Console 168RC User Manual
Page 92
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. System connection examples
A recording system using two 168RC units and two odat units
O Use a MIDI cable to connect the first 168RC's MIDI IN to the second 168RC's MIDI OUT. In the
same way, connect the first 168RC's MIDI OUT to the second 168RC's MIDI IN.
Q
Connect the first adat's SYNC OUT to the second adat's SYNC IN. Operations on the first unit
will cause the second unit to function as well.
Q Connect the optical output of each adat to the IN-A of the respective 168RC.
O Set the MISC mode CLK source to "DIG-B" ifor the first 168RC, and to "INTERNAL" for the
second 168RC.
If the first unit is an adat XT, set the adat XT's CLOCK SOURCE to "DIG 48K".
0 In the 168RC's MIDI mode, set System Extension to "Cascade Master" for the first I68RC, and
to "Cascade Sender" for the second 168RC.
0
On the second 168RC, assign Master L/R or Solo L/R etc. to Dig-Out-B in Ex.BUS lO mode.
Eor Ex.BUS lO mode Input Sel. on the first 168RC, input the Master L/R or Solo L/R etc. that
was assigned to DIG-Out-B on the second 168RC into the same bus.
adat
adat
Master recorder (DAT)
85