KORG Soundlink DRS REcording Console 168RC - Manual (Page 26)

7 .
Monitor the signals input to channels 9 and 10
6. Input the keyboard signal to channels 9 and 10
Make settings so that the signal from the keyboard connected to LINE IN G and H is input to
channels 9 and 10, and the direct sound is output in stereo to the monitor.
O Set channel faders 9 and 10 to the 0 dB position. (At the 0 dB position, the upper and lower
fader indicators will light.)
O Input the LINE IN G signal to channel 9, and the LINE IN H signal to channel 10. Press the [1/
S/P] key (the LED will light) to access 1/S/P mode. Press the channel 9 [SEL] key, then press
the [ /\ ] key or [ \/ ] key to select the Input line, and rotate knob [1] to select "ANA-G". Then
press the channel 10 [SEL] key and set Input to "ANA-H".
0
In I/S/P mode, set the channel 9 and 10 Aux (Aux Send) 1 and 2 Levels to "0".
O In I/S/P mode, set the channel 9 and 10 Eff (Effect Send) 1 and 2 Levels to "0".
0
In I/S/P mode, set the channel 9 Pan to "L50" and the channel 10 Pan to "R50".
0
In EQ mode, set the channel 9 and 10 EQ In to "OEE".
7. Monitor the signals input to channels 9 and 10
Make settings to monitor the keyboard signals that are input to channels 9 and 10.
O Send the channel 9 and 10 signals to the master L/R. In the BUS mode Bus Assign page, turn
Master "ON" and all others "OFF" for channels 9 and 10.
Master ea ST-Group Qi
m:i
EBa
I
GIQ G25) G3Q G40 G55I G6Q) G70 G8Q)
OFF OFF OFF OFF OFF OFF OFF OFF
Switch off (LED dark) the [MUTE] keys for channels 9 and 10 and the master.
Raise the master fader to the 0 dB position.
While watching the MASTER level meter, use the [TRIM] knob to adjust the volume of the
connected keyboard.
Adjust the [MONITOR] knob and [PHONES] knob to a comfortable listening volume.
19