Futaba 4GRS - Manual (Page 101)

30 seconds wait is displayed
on the receive side screen.
Transfer execution button
- (+) and (-) buttons pressed
simultaneously for about 1
second.
Mode selection
"TRANSFER" "RECEIVE"
Setup item selection
- Select by (JOG) button up or
down operation.
Mode change button
- Use the (+) and (-) buttons to
make adjustments.
"COMPLETE!" is displayed.
"RCV ERROR!" is displayed.
"CANCEL" is displayed.
101
Fu
nc
tio
n
2
(Select the setting item )
"MODE" by the (JOG) button up or down op-
eration, and select the transfer side and re-
ceive side by (+) or (-) button.
"TRAN" :Data transfer side
"RECV" :Data receive side
3
(Data transfer execution)
Select the setting item "EXEC" using (JOG)
button up or down operation of both transmitter.
First, press the receive side "RECV" trans-
mitter (+) and (-) buttons simultaneously. The
message "RCV WAIT.." appears and count
down begins.
Within 30 seconds, press the transfer side "TRANS" trans-
mitter (+) and (-) buttons simultaneously. (If data transfer is
not executed within 30 seconds, an error will be displayed at
the receive side "RECV" transmitter.)
-"COMPLETE!" is displayed
on the screen of the receive
side "RECV" transmitter and
data transfer is ended.
-If "RCV ERROR!" is displayed on the screen
of the receive side "RECEIVE" transmitter, da-
ta transfer was not performed normally. Check
the connection and repeat steps 1 3. Since
the transfer side "TRANS" transmitter only
sends, "COMPLETE!" is displayed even when
data transfer was not performed normally.
Data transfer can also be canceled before the
end of transfer by operating the (JOG) button
at a T4GRS that is waiting to receive data.
When completed, return to the DISP MENU
screen by pressing the (JOG) button.
Data Transfer "MDL TRANS"