Futaba 4GRS - Manual (Page 20)

OFF
DISP
Radio waves are not being transmitted
MIDDLE
When you do not run, turn OFF.
It cannot operate.
PWR ON
Radio waves are being transmitted
DOWN
UP
LCD screen
LCD screen
20
B
efo
re
Usi
ng
Power & Display Switch
The power switch and display switch of the T4GRS are inte-
grated. In the PWR ON mode, radio waves are transmitted
and in the DISP mode, model data, settings can be checked
without transmitting radio waves.
In addition, some setting menus may only be displayed in
the DISP mode.
Precautions when turning the power switch on and off.
- When the data is changed using the edit buttons or trim levers, wait at
least two seconds before turning off the power. If the power is turned off
within two seconds after the data is changed, the new data will not be writ-
ten to memory.
- If the power switch is quickly switched from the DISP mode to the PW
ON mode or vice versa, the switch error shown at the right may be gener-
ated. If this occurs, cycle the power.
Power ／ DISP
Switch