Futaba 4GRS - Manual (Page 83)

83
Fu
nc
tio
n
Dual ESC mixing "DUAL ESC"
The programmed DT button is used to select the drive type
as shown in the figure below.
The function select dial function can control the 4th channel’s ESC (Rear drive) rate
(RATE) with digital dial or digital trim, using the function select switch dial function.
Dial / Trim Setting
As this function drives 2 separate motor controllers simultaneously, a mutual load is
applied. Use this function carefully so that the motor controllers are not damaged. Fu-
taba will not be responsible for motor controller, motor, and other vehicle trouble due
to use of this function.
Note:
Rear rate (RATE)
0 ~ 120
Initial value:100
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) but-
tons simultaneously (approx.
1 sec).
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Trim mode (TRIM)
OFF, ON
Initial value: OFF
2
(Rear drive travel adjustment)
Select the setting item "RATE" by the (JOG) button up or
down operation. Use when applying a rotation difference to
the front and rear wheels by adjusting the rear (CH4) motor
controller travel with the (+) or (-) button.
3
(Mix mode setting)
Select the setting item "MXMD" by the (JOG) button up or
down operation. Set the mix mode with the (+) or (-) button.
"OFF" : CH2 EXP function and other settings are not mixed.
"ON" : CH2 EXP function and other settings are mixed.
4
(Trim mode setting)
Select the setting item "TRIM" by the (JOG) button up or
down operation. Set the trim mode with the (+) or (-) button.
"OFF" : Front drive (CH2) trim data is not included.
"ON" : Front drive (CH2) trim data is included.
5
When completed, return to the MENU screen by moving the
cursor to the positions other than SW/DIAL and pressing the
(JOG) button.
Select button
- Select with the (+) or (-) but-
tons.
Select button
- Select with the (+) or (-) but-
tons.