Fu nc tio n – Futaba 4GRS User Manual
Page 107
Status display
RST :Reset state
RDY :Throttle stick operation wait
RUN :Timer running
GOAL: Timer stopped
Status display
RST :Reset state
RDY :Throttle stick operation wait
RUN :Timer running
GOAL: Timer stopped
Alarm time (ALRM)
OFF, 1 ~ 99 m
Initial value: 5 m
107
Fu
nc
tio
n
Timer Function "TIMER"
(Preparation)
Select the setting item "TYPE" using the (JOG) button.
Press the (+) or (-) button and select "LAP".
1
(Alarm time setting)
Select the setting item "ALRM" using the (JOG)
button and set the alarm time with the (+) and
(-) buttons.
2
(Timer start/ lap count/ stop operation)
When the Timer switch (set in the Function select menu) is
pressed, the timer starts. During operation, the same switch
becomes the lap switch and when the set time elapses, the
timer is stopped by the same switch (TIMER)
- Linking start only to the throttle stick
Select the setting item "RST" by the (JOG)
button and press the (+) and (-) buttons simul-
taneously for about 1 second. When the set
beeps and the status display switches from
"RST" to blinking "RDY", the system enters
the stick operation ready state. When the stick
is operated in the forward direction, the timer
starts. (Status display "RUN")
When the switch (TIMER) is pressed after the time set by
alarm has elapsed, the timer stops and the lap time and total
time are memorized. The status display becomes "GOAL".
If the (JOG) button is pressed while the timer is operating,
the LCD returns to MENU2 screen.
3
(Timer reset operation)
Select a status display ("GOAL") using the
(JOG) button and press the (+) and (-) buttons
simultaneously for approximately 1 second.
A beeping sound is generated and "RST" ap-
pears on the status display and the timer re-
sets.
- If the reset operation was performed before the "ALRM"
set time had elapsed, the total time is not memorized.
- The lap memory data can be checked with the lap list
screen.
Using the Lap timer
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons si-
multaneously (approx. 1 sec) to
return to the HOME screen.
Switches
Timer start / Lap count