Futaba 4GRS - Manual (Page 81)

The function select switch
screen can be displayed
from this screen.
< NO SW >
I f f u n c t i o n ’s O N / O F F
switch is not selected,
<NO SW> is displayed.
81
Fu
nc
tio
n
4WS Mixes “4WS”
1
(4WS type selection)
Select the setting item "MODE" using the
(JOG) button up or down operation. Use the
(+) or (-) and set the function to the "ON" or
"OFF" state.
"INH" :Function OFF (front only)
"2TYP" :Front axle only, reverse steer switching
"3TYP" :Front axle only, reverse steer and same steer switching
"4TYP" :Front axle only, reverse steer, same steer, and rear steer only switching
Switched in the order shown in the figure below by set SW
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Rear rate (RATE)
0 ~ 100
Initial value:100
"2TYP"：Front axle only and reverse
steer switching
"3TYP"：Front axle only, reverse steer, and same steer switching
"4TYP"：Front axle only, reverse steer, same steer, and rear axle only switching
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) but-
tons simultaneously (approx.
1 sec).
2
(Rear side travel adjustment)
Select setting item "RATE" using the (JOG) button up or
down operation. Adjust the rear axle travel with the (+) or (-)
button.
3
(Mix mode setting)
Select setting item "MXMD" using the (JOG) button up or
down operation. Set the mix mode with the (+) or (-) button.
"OFF" :The EXP function of the 1st CH and other settings are not mixed.
"ON" :The EXP function of the 1st CH and other settings are mixed.
4
When completed, return to the MENU screen by moving the
cursor to the positions other than SW/DIAL and pressing the
(JOG) button.
Select button
- Select with the (+) or (-) but-
tons.
Select button
- Select with the (+) or (-) but-
tons.