Futaba 4GRS - Manual (Page 109)

Display "SYSTEM" screen by the following method:
Press
Press
CONTRA
LHT-TM
BK-LHT
SYSTEM
LHT-PW
BATT DRY4
OPE-TM
BUZZER
MENU
TH-STK
DISP
0
ALL
10s
15
65
OFF
TLMTR
ENG
5 5
RT
Press
Press
Select
"SYSTEM"
(HOME screen)
(MENU 1 screen) (SYSTEM screen) (MENU 2 screen)
Contrast (CONTRA)
-10~0~+10
Initial value: 0 CONTRA
LHT-TM
BK-LHT
SYSTEM
[ RT ]
LHT-PW
BATT DRY4
OPE-TM
BUZZER
MENU
TH-STK
DISP
ALL
10s
15
65
OFF
TLMTR
ENG
5 5
0
109
Fu
nc
tio
n
System Functions "SYSTEM"
System Functions "SYSTEM"
The graphic liquid crystal screen display mode, buzzer sound and menu character mode,
etc. can be set.
- "CONTRA"---Liquid crystal screen contrast adjustment (20 steps)
- "BK-LHT"---Liquid crystal screen backlighting display mode setup
(OFF, ON at button operation, normally ON)
- "LHT-TM"---Setting of ON time (1~30 secs) when [ON at button operation] was selected above.
- "LHT-PM"---Liquid crystal screen backlighting brightness adjustment (30 steps)
- "BATT"---Battery type setting (LiFe2/NiMH5/DRY4)
The T4GRS can use an optional rechargeable battery. However, the battery alarm setting is dif-
ferent from that of the dry cell battery (alkaline battery recommended). Therefore, always set the
battery type to match the power source used.
If used with the incorrect setting, the normal low battery alarm function will not work and the sys-
tem may stop before a battery alarm is generated. The usage time may also become extremely
short.
- "BUZZER"---Buzzer sound tone adjustment (OFF, 100 steps)
- "OPE-TM"---Alarm Setting if Tx is left switched ON (OFF, 10 m)
- "MENU"---Item which displays the basic menu screen in katakana characters for Japanese use.
- “TH-STK”---This is used, when the neutral adjuster of throttle stick is changed, or when it is
changed into ratchet.(5:5, 7:3, F10)
- "DISP"---HOME screen display mode setting (Telemetry data, Timer, Users name)
1
(Setting of each item)
(Adjusting the liquid crystal contrast)
Select the setting item "CONTRA" using the
(JOG) button, and use the (+) and (-) buttons to
adjust the screen contrast.
- Adjust to an easy-to-see contrast.
When completed, return to the MENU2 screen
by pressing the (JOG) button.
System function setup Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons si-
multaneously (approx. 1 sec) to
return to the initial value.