Futaba 4GRS - Manual (Page 39)

R304SB
(Error screen)
39
In
itia
l S
et
-Up
*When using an FHSS (R603GF/R2004F, etc.) or S-FHSS(SFH) system (R2104GF,
R204GF-E, etc.) receiver, after the end of setting up to here set the transmitter power
switch to OFF and go to
"Receivers other than T-FHSS" .
3
Bring the transmitter and receiver to within 50cm of each other (do not allow the anten-
nae to touch) and turn on the receiver power.
4
Move the cursor to "LINK: EXE" by (JOG) button up or down operation.
When the (JOG) button is pressed
for approximately 1 second, "PUSH
RX LINK SW" appears on the
screen and 20 seconds countdown
begins. Countdown can be can-
celled at any time using button up
down or left right operation.
5
During 20 seconds countdown,
press the receiver link switch for approximately 2 seconds. The LED will begin to blink
red. After the receiver LED switches from blinking red to green-red steady light, the
T4GRS generates an electronic beeping sound, and "LINK:OK" and "COMPLETE!" ap-
pear on the screen, reading of
the mutual IDs ends and the
memorized receiver ID num-
ber appears on the T4GRS
screen. If an error screen was
displayed, linking failed. Retry
linking. If the transmitter and re-
ceiver are linked normally, set
the power switch to the OFF
position and then return it to
the PWR ON position. If the receiver LED lights green, linking was successful. Check for
correct servo operation.
*The T4GRS and a telemetry type T-FHSS receiver (R304SB, etc.) mutually memorize
the combined ID linked last at each model memory.
Since the T4GRS can memorize only 1 receiver ID at each model memory, multiple T-
FHSS receivers cannot be used with the same model memory. If the same model mem-
ory is used for more than one model it will be necessary to re-link the receiver’s each
time a different model is operated.
When using multiple telemetry type T-FHSS receivers, link and combine them with each
T4GRS model memory.
Note however that, multiple receivers cannot be linked to multiple model memories.
The telemetry function communications status can be checked at the T4GRS HOME
screen.