Futaba 4GRS - Manual (Page 80)

Front axle only
（ 4WS OFF）
Same steer Reverse steer Rear axle only
Press
Press
Press
(HOME screen)
(MENU 1 screen) (4WS screen) (MENU 2 screen)
Press
Select
"4WS "
80
Fu
nc
tio
n
This function can be used with crawlers and other 4WS type vehicles. It is mixing which
uses the 1st CH to control the front axle steering and the 3rd CH to control the rear axle
steering.
OFF (front axle only), reverse steer, same steer, rear axle only and other 4WS type
switching is used by selecting SW1 with the function select switch function. If not se-
lected, <NO SW> is displayed. Therefore, select SW1.
4WS Mixes "4WS" (Steering, 3rd channel system)
Setup items
MODE ：4WS Type
RATE ：3ch rate (Rear side)
MXMD ：Mix mode
4WS Mixes “4WS”
(Preparation)
Since this function is used by switching the type of 4WS with
a switch, the switch used by the function select switch dial
function is set.
4WS mixing adjustment
When the 3rd CH was set to ACT at Brake Mixing or when Gyro Mixing is used, 4WS
mixing cannot be used.
Setting Special mixings
Display "4WS" screen by the following method:
Function SW
4WS