Futaba 4GRS - Manual (Page 38)

FHSS T-FHSS Normal speed
T-FH (NORM)
S-FHSS Normal speed
S-FH (NORM)
T-FHSS High speed
T-FH (HIGH)
S-FHSS High speed
S-FH (HIGH)
Push
Select "RX MODE"
by (JOG) button.
Push
Select TYPE with
the (+) or (-) but-
ton.
Select RX type with the (+)
or (-) button.
Press the (JOG) buttons
continuously for approxi-
mately 1 second.
( +) button ( -) button
(JOG) button
DISP
DOWN
38
In
itia
l S
et
-Up
If the receiver used and the RX type settings are different, change the RX type using
the "RX MODE" function. Which RX type is set can be checked at the HOME screen.
Receiver Type Change & How To Link
The first operation described below sets the RX type. Next, the transmitter and receiver
are linked and the transmitter ID number is memorized at the receiver so that signals
from other transmitters will not be received. The telemetry type T-FHSS also simultane-
ously memorizes the ID number of the receiver at the transmitter so that data from other
receivers will not be received.
The RX type setting and transmitter and
receiver linking methods are described
here. Refer to the figure at the right for
the edit buttons used.
1
Set the transmitter
power switch to DISP.
Select "RX Setting"
using (JOG) button
u p o r d ow n o p e ra -
tion, and display the
"RX MODE" screen
by pressing the (JOG)
button.
2
Move the cursor to "TYPE: ----" using (JOG) button up or down operation, and select the
RX type with the (+) button or (-) button.
When the (JOG) button is pressed for approximately 1 second, an electronic sound is
generated and setting ends.