KERN & SOHN CCS Version 2.0 - Manual (Page 52)

52 CFS/CCS-BA-e-1220
CFS 3K-5, CFS 6K0.1, CFS 15K0.2, CFS 30K0.5 models:
 Press , tolerance control is started. The  symbol over appears.
 Determine the average piece weight (see chap. 11.1 or 11.2), place the weighing
goods and check using the tolerance mark , if the number of the placed pieces
is under, within or above the specified tolerance.
Display of tolerance mark , if weighing goods are under the specified tolerance
Display of tolerance mark , if weighing goods within the specified tolerance
Display of tolerance mark , if weighing goods above the specified tolerance:
The information if the goods to be weighed are within the tolerance limits, can
additionally be
given by an acoustic signal (menu item „ „ see chap. 13.2)
For tolerance control, also only one limit value can be set.
If both limit values are deleted, the tolerance control is deactivated.