PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 119)

T ESTING AND T ROUBLESHOOTING : T EST S OFTWARE
0 2. 3 0 0 4. 0 3 00 . 5 4 111
4
1 Spin gobos CW (25%) wheel
does not move
0 Spin gobos CW (100%)
wheel does not move
010 Strobe Test 9 Strobe to EOT stop (65%)
(CLSD)
8 Strobe to middle position
between EOT Stop (66%)
(OPEN)
7 Strobe open to closed stop
repeatedly (25%) (i.e.
cycling)
6 Cycling (35%)
5 Cycling (45%)
4 Cycling (55%)
3 Cycling (65%)
2 Cycling (75%)
1 Cycling (85%)
0 Cycling (Full Speed)
013 All Async All tests above will run asyn-
chronously. All motors will
reach respective EOT stop (if
applicable) and begin motion
to opposite EOT stops at
each motor’s earliest oppor-
tunity. Motion will not be coor-
dinated between motor.
Flashing display indi-
cates sensor not hit.
Solid display indicates
sensor hit.
021 Sensors 9 Monitor Lens 3 Sensor
8 Monitor Lens 2 Sensor
7 Monitor Lens 1 Sensor
6 Monitor Strobe Sensor
5 Monitor Fixed Gobo Sensor
4 Monitor Rotating Gobo
Wheel, Wheel position Sen-
sor and Gobo Orientation
Sensor
3 Monitor Plate 2 Saturation
Sensor
2 Monitor Plate 2 Color Sensor
1 Monitor Plate 1 Saturation
Sensor
0 Monitor Plate 1 Color Sensor
022/
023
Pan/Tilt Encoders 9 Display current most signifi-
cant digit (Xxxx) of the
reported encoder value.
Repeatedly monitored.
Table 4-9: VL7B/VL7UB Spot Luminaire Mechanical Tests (Continued)
Test Number Test Parameter Error Codes/Comments