PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 86)

DMX512 R EFERENCE G UIDE
7 8 02.3004.0300.54
Note: It may be necessary to add a piece of gaffer’s tape at the joint between the two halves to stop the
yoke from catching.
VL4 Sound Baffle
Figure 3-15: VL4 Sound Baffle
To install VL4 sound blanket:
Step 1. Route safety cable through eyelet in sound baffle.
Step 2. Align sound baffle with air intakes.
Note: Because of the baffle's tight fit, it may be necessary to remove the air filters before installation
in some cases.
Step 3. Push down bottom flanges of baffle between bottom lips of fan intakes and air filters (if
installed).
Step 4. Push up top flanges of baffle between top lips of fan intakes and air filters (if installed).
Step 5. Ensure that baffle fits snugly.
4ECA009