PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 4)

DMX512 R EFERENCE G UIDE
ii 02.3004.0300.54
WARNING: INSTRUCTIONS FOR PROTECTION AGAINST INJURY TO PERSONS
1. Exterior surfaces of the luminaire will be hot during operation. Use appropriate safety equipment (gloves,
eye protection, etc.) when handling and adjusting hot equipment and components. Service and maintenance
should be performed only by qualified personnel as determined by the high pressure lighting fixture
manufacturer.
2. Arc lamps generate intense heat. Disconnect power and allow lamp to cool for 15 minutes before relamping.
3. Arc lamps emit ultraviolet radiation which can cause serious skin burn and eye inflammation. Additionally,
arc lamps operate under high pressure at very high temperatures. Should the lamp break, there can exist a
danger of personal injury and/or fire from broken lamp particles being discharged.
4. The lamp shall be changed if it has become damaged or thermally deformed.
5. Wear eye protection when relamping.
6. If lamp is touched with bare hands, clean lamp with denatured alcohol and wipe with lint-free cloth before
installing or powering up the luminaire.
7. Serious injury may result from the generation of ozone by this lamp system. A proper means of venting must
be provided.
Revision History
This manual has been revised as follows:
Version Release Date Notes
BASIC April 16, 2008 Initial release for DMX software version 5.4
Note that this manual was converted to the PRG for-
mat from a legacy VARI
❋
LITE® manual.