PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 83)

S YSTEM : A CCESSORIES
0 2. 3 0 0 4. 0 3 00 . 5 4 75
3
To install the optional sound baffle kit:
Step 1. Disconnect power to luminaire.
Step 2. Disconnect two latches and remove bottom head cover.
Step 3. Install counterweight as shown in illustration.
Note: The counterweight is secured to the inside of the bottom head cover with adhesive-backed
velcro. Both hook and loop velcro pieces are pre-installed on one side of the counter-weight.
a. At bottom of counterweight, remove adhesive backing from velcro. Leave velcro
attached to counterweight.
b. Inside bottom cover, at flat section, center counterweight left and right and install
against front edge. Press firmly to adhere velcro to bottom cover.
Figure 3-12: Installing VL7 Sound Baffle Counterweight
Step 4. At head assembly, install bottom head cover and secure latches.
Step 5. Install sound baffle.
a. Place baffle over top head covers.
b. Stretch elastic cords around front and rear sections of head assembly.
CL
Install counterweight in
center against front edge
of flat section.
CL
Front