PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 91)

S YSTEM : S YSTEM H OOK -U P
0 2. 3 0 0 4. 0 3 00 . 5 4 83
3
Step 12. Connect Series 200 trunk cables.
a. Connect plug end of Series 200 trunk cables to ACS or mini-ACS rack trunk cable
outputs.
b. Connect receptacle end to Repeater Box.
Step 13. Connect Series 200 lamp cables.
a. For Series 200 luminaires, attach plug end of Series 200 lamp cable to Repeater Box
output. Remember to phase-balance Repeater Box. Refer to "Phase Balancing" on page
21 .
b. Connect receptacle end of lamp cable to luminaire. Make sure to use correct length of
lamp cable to avoid having too much excess. Avoid using many short lamp cables
connected together since the more interconnections that exist, the more noise and
maintenance problems that may develop.
Step 14. Perform final inspection.
Ensure that all components are securely connected and that all hanging equipment’s safety
cables are in use. Ensure that cabling is routed safely.
Step 15. Perform system checkout and troubleshooting.
For more information see "Series 200 Checkout" on page 90.