PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 55)

E QUIPMENT D ESCRIPTION : C ABLES
0 2. 3 0 0 4. 0 3 00 . 5 4 47
2
Cables
Note: Refer to "Cable/Connector Terminology" on page 3 for appropriate metric equivalents.
Pig Tails
The pig tails used for the 200A AC Line Disconnect are a set of 10-foot, 2/0 power cables with Cam-
Lok receptacle connectors on one end and bare wires on the other end. The bare wires are used to
connect to the house service.
The pig tails used for the 30A mini-ACS line disconnect are a set of 10-foot, 8/5 power cables with
bare wires on one end and a Hubbell receptacle connector on the other.
Power Input Cables
The power input cables are 2/0 cables rated at 200A, using color-coded Cam-Lok connectors to denote
three phases, neutral, and ground. The cables are available in 20- and 80-foot lengths with Cam-Lok
connectors on both ends.
The power input cable for the mini-ACS rack has a Hubbell plug on one end and a Hubbell receptacle
on the other.
Mini-AC Disconnect to SixPack Chassis Input Cable
This input cable is used to supply power to a SixPack
Chassis or a NIF unit when used with a mini-AC
disconnect unit. This cable is connected to the mini-
AC disconnect using the Hubbell connector. To use
with a NIF, the Epic connector is mated to a
"modular rack-to-NIF-unit" power cable. (Note the
NIF unit end of the modular rack to NIF unit power
cable utilizes a single clamping mechanism.)
For AC Line
Disconnect
For Mini AC
Line Disconnect