PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 43)

E QUIPMENT D ESCRIPTION : P OWER AND D ATA D ISTRIBUTION E QUIPMENT
0 2. 3 0 0 4. 0 3 00 . 5 4 35
2
Dimmers
If there are VL5 luminaires in your system, you will also need to supply power to the dimmers that are
associated with these luminaires. This is not a concern if you are using the house dimming system.
However, if you are adding dimmers to your system, or are setting up all the elements of your event,
you will need to power your dimmers. In general, most dimmers require three-phase power for
operation. You should consult the operating manual provided by your dimmer manufacturer for the
proper power requirements for your dimmers.
In addition, some dimmer manufacturers reverse the ground and neutral Cam-Lok connectors on their
product. You may need to provide for specific adapters between equipment. Again, consult the
manufacturer or their authorized representative for plugging options and adapters.
In most cases, unless specifically requested, you will not receive APS6 cable (AKA Shielded Socapex
cable) with the rental of VL5 wash luminaires, unless your rental includes C3 modules and/or
dimmers. Speak with your Account Manger for equipment specifics. If the VARI
❋LITE® Series 200/
300 system is being installed into an existing light plot, the Smart Repeater units may plug directly into
circuits on electrics or battens using a "fan-in"; a male stage pin (or other male plug) to female
Socapex adapter. You may need to supply Socapex multicore and breakouts as necessary.