Toa C-RM700 - Manual (Page 27)

27
7.3. Basic Setting Operations
This section shows basic operating procedures for each setting item.
7.3.1. When the password has not been set
1. Press the Menu key for 3 seconds or more.
The menu screen is displayed.
[Some operation examples]
2. Tilt the joystick up or down to select the setting item.
3. Press the SET key to confirm the setting item.
The current setting contents (if not set, the factory-
predetermined setting contents) are displayed at the
lower part of the LCD screen.
In this event, one character "1" of the setting contents
flashes. (The flashing character differs depending on
the content.)
4. Tilt the joystick left or right to select the desired setting
content.
Note
Pressing the Clear key before Step 4 is completed will
return the display to the screen last shown (in Step 2)
before the SET key was pressed without storing the
setting contents.
5. Press the SET key to confirm the setting contents.
The display returns to the screen (in Step 2) to select
the setting item.
6. Repeat Steps 2-5 to continue to set other items.
Press the Menu key again when returning to the normal
screen after setting completion.
Note
All keys are disabled for a maximum period of 30 seconds when returning to the normal screen from the menu
screen without performing camera check if the Combination camera is not connected.
O P E R A T I O N M O D E
A U T O R E T U R N
(Example)
SET
A U T O R E T U R N
1 . O N 1
A U T O R E T U R N
1 . O N 1 0 S E C 1
SET
A U T O R E T U R N