Toa C-RM700 - Manual (Page 39)

39
7.4.16. Camera alarm preset
Sets the position number to automatically change the Combination camera's orientation when an alarm
contact close information is received from the Combination camera. Different preset reproduction positions
can be programmed into each of 8 camera alarm contact inputs. It is also possible to perform setting so that a
camera contact output that has received an alarm signal can be closed in synchronization with the alarm.
Number of contact inputs differs depending on the cameras.
Notes
• This setting can only be performed when "1. ON" has been selected in the "Camera alarm" setting. This
setting item is not displayed on the menu screen when "2. OFF" has been selected.
• When alarm settings and alarm report settings are performed on the camera, set the report settings of the
alarm contact number to be used to ON.
• Do not use the camera alarm preset settings when using the camera's alarm action settings.
• This function is not available when "TYPE B ONE WAY" is selected in the protocol setting.
1. Press the Menu key for 3 seconds or more to display
the menu screen.
2. Tilt the joystick up or down to select "PRESET CAM
ALARM," and confirm the selection with the SET key.
The Camera Alarm Preset content will appear on Line 2,
and the unit switches to Camera Number Entry Waiting
mode.
3. Enter the camera number using the numeric keypad,
and confirm it with the SET key. The flashing cursor will
move to the alarm number.
4. Tilt the joystick to the left or right to select the alarm
number, and confirm the selected alarm number with
the SET key.
The flashing cursor will move to the preset position
number.
5. Using the numeric keypad, enter the position number to
be displayed when the alarm contact is closed, and
confirm the number with the SET key.
The flashing cursor will move to the rightmost position.
6. Tilt the joystick to the left or right to select either [ ]
(space) or [*], and confirm the content with the SET key.
For the camera equipped with 2 auxiliary contact
outputs, if [*] is selected, the camera's auxiliary contact
output 2 can be set to be closed when the camera alarm
contact is closed.
7. Repeat Steps 3-6 to continue the Camera Alarm Preset
settings of other cameras. Press the Clear key to return
to the setting item display.
2
3
4
5
6
P R E S E T C A M A L A R M
SET
P R E S E T C A M A L A R M
C A M 1 A L 1 1 2 3
7 SET
(Example)
P R E S E T C A M A L A R M
C A M 7 A L 1 1 2 3
SET
P R E S E T C A M A L A R M
C A M 7 A L 5 1 2 3
P R E S E T C A M A L A R M
C A M 7 A L 5 2 5 5
SET
1
1
3
2 5 5 SET
(Example)