Toa C-RM700 - Manual (Page 7)

7
4. CONNECTABLE EQUIPMENT AND THEIR MAXIMUM NUMBERS
4.1. About Controllable Equipment by the C-RM700
Shown below are equipment that can be controlled by the C-RM700.
Camera
[Communication method: Type A]: C-CC504, and C-CC554
[Communication method: Type A/B]: C-CC514, C-CC564, C-CC574, C-CC704, C-CC714, C-CC764, and
C-CC774
Up to 16 each of camera can be connected to the camera control terminals and controlled.)
Switcher: C-MS91D, C-MS91S, C-MS161D, and C-MS161S
Only one switcher can be connected for remote camera control.
4.2. About the Camera Control Terminal
The Camera control terminal is used to connect the Combination Camera or the C-IF500 Interface Unit. Up to
16 cameras can be connected to this terminal.
After connection completion of all cameras, turn on the power of cameras and the C-RM700, and initialize the
cameras. Then be sure to perform camera check after the camera's initialization operation has been
completed. (Refer to
p. 31 , "Camera Check.")
About the Descriptions in This Manual
• The explanations in this manual assume that the C-RM700 Remote Controller (this unit) is connected to
a C-MS161D/S or C-MS91D/S Multi-Switcher.
• Camera number: Refers to the camera input terminal number connected to the switcher.
• Position number: Combination camera orientation can be programmed for No. 1-255.