Toa C-RM700 - Manual (Page 37)

37
Setting contents
Tilt the joystick to the left or right to select "1 4," "5 8," "9 12," or "13
16" and confirm the selection with the SET key.
Note: This selection is set to "1 4" by the factory.
Tilt the joystick to the left or right to select "1 9" or "10 16," and confirm
the selection with the SET key.
Note: This selection is set to "1 9" by the factory.
Enter the channel to be designated with the numeric keypad, and confirm the
setting with the SET key.
Note: This selection is set to "1" by the factory.
4. 4-SEG (4-segment
split-screen display)
Tilt the joystick to the left or right to select "1 8" or "9 16," and confirm the
selection with the SET key.
Notes
• Make sure that this setting is the same as that of the connected switcher.
• This selection is set to "1
8" by the factory.
I N I T I A L C H A N N E L
1 4 1
7.4.13. Channel designation
Sets the first channel (camera number) to be displayed after the power is turned ON.
Note
This channel setting can only be performed when one of the settings "1. FULL," "4. 4-SEG," "5. 9-SEG," or "6.
10-SEG" has been selected in the "Initial screen" setting. The Channel Designation item is not displayed on
the menu screen when another setting has been selected.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "INITIAL CHANNEL," then confirm the selection with the SET key.
The setting corresponding to the Initial Screen setting is displayed on Line 2.
3. Using the joystick and numeric keypad, select the setting depending on the "Initial screen" setting, and
confirm the selected setting with the SET key. (Refer to the table shown below.)
[Setting contents]
"Initial screen" setting
I N I T I A L C H A N N E L
1 9 1
5. 9-SEG (9-segment
split-screen display)
I N I T I A L C H A N N E L
1 8 1
6. 10-SEG (10-segment
split-screen display)
I N I T I A L C H A N N E L
C H A N N E L 1 2 3 C
1. FULL (full screen)